![]() ![]() ![]() Under this tab, click Enable Transparent Tunnelingand the IPSec over UDP ( NAT / PAT )radio button. It opens a new window where you have to choose the Transporttab. ![]() In Cisco VPN Client, navigate to Connection Entriesand click Modify. The clients need to be modified as well in order for it to work. The twenty (20) in this example is the keepalive time (default).ĪSA securityappliance(config)# crypto isakmp nat-traversal 20 Here is the command to enable NAT-T on a Cisco Security Appliance. Note: With Cisco IOS® Software Release 12.2(13)T and later, NAT-T is enabled by default in Cisco IOS®. Reason 412: The remote peer is no longer responding.error message appears.Įnable NAT-T in the head end VPN device in order to resolve this error. Similarly, if you are unable to do simultaneous login from the same IP address, the Secure VPN connection terminated locally by client. If you do not enable the NAT-T in the NAT/PAT Device, you can receive the regular translation creation failed for protocol 50 src inside:10.0.1.26 dst outside:10.9.69.4error message in the ASA. If NAT-T is not enabled, VPN Client users often appear to connect to the ASA without a problem, but they are unable to access the internal network behind the security appliance. NAT-Traversal (or NAT-T) allows VPN traffic to pass through NAT or PAT devices, such as a Linksys SOHO router. Note: Some of the commands in these sections have been brought down to a second line due to spatial considerations. Issues with latency for VPN client traffic Verify Crypto Map Sequence Numbers and Name Verify that ACLs are Correct and are Binded to Crypto Map Verify that sysopt Commands are Present (/ASA Only) This section contains solutions to the most common IPsec VPN problems.Īlthough they are not listed in any particular order, these solutions can be used as a checklist of items to verify or try before you engage in in-depth remediation.Īll of these solutions come directly from TAC service requests and have resolved numerous issues.Ĭlear Old or Existing Security Associations (Tunnels) IPsec VPN Configuration Does Not Work ProblemĪ recently configured or modified IPsec VPN solution does not work.Ī current IPsec VPN configuration no longer works. Refer to Cisco Technical Tips Conventionsfor more information on document conventions. If your network is live, ensure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. The information in this document is based on these software and hardware versions: Prerequisites RequirementsĬisco recommends knowledge of IPsec VPN configuration on these Cisco devices: It is recommended that these solutions be implemented with caution and in accordance with your change control policy. Warning: Many of the solutions presented in this document can lead to a temporary loss of all IPsec VPN connectivity on a device. Note: ASA does not pass multicast traffic over IPsec VPN tunnels. Refer to IP Security Troubleshooting - Understanding and Using debug Commandsfor an explanation of common debug commands that are used to troubleshoot IPsec issues on both the Cisco IOS ® software and. This document provides a summary of common procedures to try before you begin to troubleshoot a connection.Īlthough the configuration examples in this document are for use on routers and security appliances, nearly all of these concepts are also applicable to the VPN 3000. Many of these solutions are implemented prior to the in-depth troubleshooting of an IPsec VPN connection. The solutions described here come directly from service requests that the Cisco Technical Support have solved. This document describes the most common solutions to IPsec VPN problems. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |